1. Aspirate the medium from the cell culture tubes to be preserved.
2. Add 8 mL buffered formaldehyde preservative medium to each tube.
3. Record the following information on the tube:
- virus
- number of days incubation
- lab number
4. Store preserved culture at room temperature.
Formaldehyde Preservative
100 mL Formaldehyde Solution (37 - 40%)
900 mL Distilled Water
20 mL Phenol Red (0.5%)
4.0 g NaH2PO4 - H2O
6.5 g Na2HPO4
Materials
Vortex
Sterile pipettes
10 - 100 uL Eppendorf pipette
Humidified chamber
Coplin jars
Fluorescent microscope
Appendix XIV
QUALITY CONTROL OF CELL CULTURES USED FOR ROUTINE VIRUS ISOLATES
Tube Culture (Not in routine use)
Upon receipt of cell culture tubes, the record of the date received, vendor, lot number, and passage number is kept in the QC binder for cell lines. The monolayer is checked microscopically for sterility and appearance of an acceptable confluent monolayer.
A. Uninoculated Negative Controls:
Reserve 4 tubes of each lot cells for use as controls and label as follows:
N1, date;
N2, date;
N3 date;
C, date;
V, date
a. Negative Controls with refeed: (3 tubes, N1; N2; N3)
Select one tube each on Wednesday Friday and Monday to set up along with inoculated specimens. Incubate, observe and refeed these tubes in parallel with patient inoculated cultures to monitor monolayer quality, toxicity and sterility. They can also be used to provide a baseline for comparison of inoculated cultures when reading for CPE and immunostaining. CMK and HFF tubes are kept for 3 weeks, HEp-2 and RD for 2 weeks
b. Unopened Negative Controls without refeed: (2 tubes, C; V)
These tubes are left unopened and observed to identify toxicity and contamination originating with the vendor. All tubes, CMK, HEp-2 , HFF and RD tubes are kept for only one week. One tube (C) is kept in the clean room and one (V) is placed on the Virology drum.
Record sterility and cell appearance for these tubes into the LIS Manual (REGISTRATION OF TUBE CULTURE MEDIA)
B. Positive Controls:
Each week scrape from an HFF tubes containing the following QC strains of HSV-1 HSV-2 and CMV to propagate the QC strains in the new lot of HFF tubes, Use CMK tubes for RSV and nfluenza A. Examine microscopically for CPE and record the results into the LIS as growth control. At the same time also inoculate MRC-5 and R-Mix shell vials to perform quality control for MRC-5 shell vials (see II. Shell Vial Cell Lines (MRC-5 cell suspension below)
HSV-1 (ATCC VR-5539)
HSV-2 (ATCC VR-540)
CMV (ATCC VR-807)
RSV (ATCC VR-284)
Influenza A (ATCC VR-544)
The MRC-5 shell vials are then stained with HSV-1, HSV-2 and CMV IEA monoclonal antibodies at 24 hours, R-Mix shell vials with RS. Record the results into the LIS as shell vial growth control as well as stain controls.
Each month (and whenever necessary), remove from the liquid nitrogen storage, cryovials of above strains to propagate the QC strains in HFF tubes.
Additional positive controls may be set up with the following strains and for the following reasons:
Coxsackie B1 (ATCC VR-28)
Parainflunza 3 (ATCC )
Varicella-zoster (ATCC VR-1367)
i) Low isolation rates
ii) Comparison of cell lines
iii) Vendor changes
iv) Proficiency test failures
v) Training purposes
vi) Consistent problems with negative controls
vii) Preparation of QC material (i.e. Positive control slides)
Consult a senior technologist to determine the cell lines and viruses to be set up.
II. Shell Vial Cell Line (Suspension seeding is not in routine use)
Upon receipt of a shipment of cells, initial and date the record sheet accompanying the shipment. The record should contain vendor, lot number, passage number and QC data. File in the QC binder for cell lines.
Before seeding the shell vials, aspirate about 30 mL of MRC-5 cell suspension into a 125 cm2 tissue culture flask, label on the side of flask with “MRC-5, date and ‘Pre’”.
After seeding shell vials, aspirate about 30 mL of MRC-5 cell suspension into another 125 cm2 tissue culture flask, label on the side of flask with “MRC-5, date and ‘Post’”.
Reserve 6 shell vials for use as negative and positive controls as follows:
A. Negative Controls for this week, also become Positive Old Lot for following week (3 Vials)
These are incubated at 36oC and observed daily for one week or more to identify toxicity and contamination originating with the vendor. Results are recorded on the QC chart.
Three shell vials are reserved to QC the next shipment in parallel after the cells are added.
B. Positive Controls (3 Vials)
Each week, usually 2-3 days after seeding the shell vials, HFF tubes containing HSV-1 (ATCC VR-5539), HSV-2 (ATCC VR-540) and CMV (ATCC VR-807) are scraped from and used to inoculate 6 MRC-5 shell vials, 3 from the current lot and 3 from the previous lot (the same 3 vials were used as Negative Controls for a week). The shell vials are then stained with HSV-1, HSV-2 and CMV IEA monoclonal antibodies after 1 day incubation. Record the results into the LIS daily QC under the following codes:
a. VHSV1D HSV1 daily SLIDE SV QC
b. VHSV1D HSV1 daily SLIDE SV QC
c. VCMV-D CMV-IE daily SLIDE SV QC
d. VQCSV Shell Vial MRC-5 Quality Control
BAHAN KULIAH DAN MAKALAH KESEHATAN : http://bahankuliahkesehatan.blogspot.com/2011/08/appendix-xiii-preservation-of-cell.html
